Windster RA-7748SS Instrukcja Użytkownika Strona 1

RA-7730SS RA-7736SS RA-7742SS RA-7748SSFor residential and indoor use only.

88Fig. 18Fig. 23Fig. 23 Measure and balance the recirculation exhaust and line it up with the exhaust opening in the duct cover. Fig. 24Fig. 24 I

1093WAL700AL70027Test the LED lights after putting the LED lights back into original position.

10ProblemCheck power plug to see if it is plugged firmly into the power socket.

109111111 28 28Range hood should be turn on before cooking to create air pocket.After cooking, range hood should be kept on for additional time until

12Model:RA-77 SeriesSwitchSwitch holder

13Fig. 29 RA-77 Series Electrical Schematic DiagramWhiteRPowerBlackWhiteLED DriverGreenMotorBrownWhiteBlueGrayRedLED LEDCapacitorYellowRA-77 SERIESSe

14

What Is Not Covered By These Warranties: 1) Conditions and damages resulting from any of the following: Improper installation, delivery, or mainte

Defective Products: All products will be inspected, tested, and carefully packed by the manufacturer before shipping to customers. Products that are

5101 Commerce DriveBaldwin Park, CA 91706TEL: (626)962-8600FAX: (626)962-8669

WINDSTER recommends that all kitchen range hood be installed by a certified installer.Limited Warranty P.15-P.164

27” 35”27”-35”If the hood is mounted too low, it may caused heat damaged and fire hazard.

A. Use this unit only in the manner i IMPORTANT SAFETY INSTRUCTIONSWARNING – To reduce the risk of fire, electric shock, or injury to persons, observe

- All electrial work have to be done by certified electrician.- This range hood requires a 120V/60Hz electrical supply and must meet local required

.Duct cover and extension duct cover fitment may vary depend on the mounting height of therange hood.Installation and Maintenance must be carried out

6Fig. 6 Fig. 7Fig. 10Fig. 9Fig. 8Fig. 11Use a level to balance out both sides to ensure the hood will be properly mounted.Mount the unit onto the wall

7Fig. 12Fig. 14Fig. 15Fig. 16 Fig. 17Fig. 13 Evenly slide duct cover into the slot of theBlack plastic plate.Correctly align the duct cover into bla